"Long Engine Life Starts With Reiff"

Main Page  |  Place an Order  | Contact Us  |  FAQ


 

Installation & Operating Instructions

 

HotBand Cylinder Heat System

HotStrip Oil Sump Heater

HotPad Oil Sump Heater for oval tanks on small Contintentals

Rotax 912 System

Oil Cooler Preheat System

How to remove and reinstall the aluminum HotStrip oil sump heater:

Drive a putty knife or other thin blade under the heater to separate it from the surface. Keep the blade flat to the sump. Do not use a screwdriver or pry on the heater, if you bend it the resistance wire may break and ruin it. Clean off the old epoxy with epoxy stripper, available in most hardware stores (for example www.homedepot.com/p/Jasco-1-qt-Premium-Paint-and-Epoxy-Remover-QJBP00202/202247418 ). Then rebond it to the new engine following the HotStrip Oil Sump Heater instructions. Order epoxy from us or use JB-Weld high temp epoxy #8265.

 

 

How to safety wire a cylinder heater clamp

 

 

Lyc IO-360 oil sump heater location

 

 

Lyc IO-360 oil sump heater location

 

 

Lyc IO-360 oil sump heater location

 

 

Superior IO-360 with cold air induction - oil sump heater location.

 

 

Updated 10-7-2017